|
TonyJ
Posts: 59
Joined: 12/11/2003
Location: Marietta, GA
 User Profile |
I would like to manually trade the Resilient ATM system. I added the ATPos (ATM/ATS Position) and ATPerc (ATM/ATS Percentage) columns to the Focus List. The ATPos column shows squares for the symbols that were closed on Friday.
Is there a way to see the trades that the Resilient ATM system would take when the market opens on Monday?
Any information on how to trade this manually would be appreciated.
|
|
Barry Cohen
Posts: 6338
Joined: 1/19/2004
User Profile |
It needs to be ran on Monday any time before market open & then it will give you the trades. I don't know if there's a way around that currently.
|
|
Buffalo Bill
Posts: 539
Joined: 10/3/2006
Location: Stafford, VA
User Profile |
I am also using resilient to trade in my 401k so I need the signals earlier than mon morning. I changed the entry to MOO and exit to mkt.
I have AT run it after mkt close each day so I got Monday's entries fri night.
All the exits are Fri MOC so you know that part.
I entered monday's trades into schwab already. The only problem is schwab, like most large brokerages, offers nada for exits - no MOC exit. So each fri afternoon I'll have to get on and manually exit (used mkt exits at 3:45pm last week, manually) or put a tight trailing stop on if I can't do that. It's ridiculous how bad these brokerages really are
|
|
TonyJ
Posts: 59
Joined: 12/11/2003
Location: Marietta, GA
User Profile |
Hi Barry,
I tried running the To Do List this morning a little before 9:15 EST (~15 minutes before open). Unfortunately, this did not work. After running, I still see the closing trades from Friday and do not see the new trades for Monday. I'll try attaching a couple of screenshots showing the To Do List running and completing without new trades.
BTW, when I ran the To Do List a few minutes after 9:30, I am able to get the new trades.
 Attached file : 920amComplete.jpg (300KB - 306 downloads)
Attached file : 917amFinalRun.jpg (283KB - 315 downloads)
|
|
JEM
Posts: 35
Joined: 1/28/2007
Location: victoria bc
User Profile |
Barry,
I tried running AT about 2 hours apart.
This resulted in getting 2 quite different trade lists.
In the second list, closest in time to trade execution, there were 4 similar symbols, 7 totally different symbols and all symbol $ sizes were different.
I notice that DOG appeared in the second list. I seem to remember in one of the webinars that the final run for DOG was done very close to the exchange opening time.
Is it possible that the cause for the large differences is the different times that DOG was run ??
|